SoftEther VPN User Forum

Dear, thanks the author of this great software to free for the community.

I have a adsl router (huawei HG556) with IPSEC cliente integrate for doing LANtoLAN VPN.
I d like to know how to setup to connect to a ethersoft server installed in linux server. This server is able to accept embeded XP client (L2TP-IPSEC).
I attach images with router view.
[attachment=0]ipsec_transport.jpg[/attachment]
[attachment=1]ipsec_tunnel.jpg[/attachment]
ROUTER show this setup view:
IPSec Settings
IPSec Connection Name :
Remote IPSec Gateway Address (IP or Domain Name)

Access from local IP addresses
IP Address for VPN
IP Subnetmask

Access from remote IP addresses
IP Address for VPN
IP Subnetmask

TransMode
Protocol
Interface
Key Exchange Method
Authentication Method
Pre-Shared Key
Perfect Forward Secrecy

Advanced IKE Settings
Phase 1
Mode
Encryption Algorithm
Integrity Algorithm
Select Diffie-Hellman Group for Key Exchange
Key Life Time Seconds (120 - 8640000)

Phase 2
Encryption Algorithm
Integrity Algorithm
Select Diffie-Hellman Group for Key Exchange
Key Life Time

thanks

Check this http://www.softether.org/4-docs/2-howto ... uter_Setup, it may help you to configure your router.

I have readed that document yet , but doesnt apply for my case.
MY router has a classic IPSEC config , transport or tunnel, but authentication is with PSK .
This is the same type I see in other routers i have here, as image show.
So question remain the same:
Can my router connect with IPSEC (but not L2TP) to softether server ?
how to ? tunnel or transport mode? ESP or AH ? encription algorythm ?

thanks