Page 1 of 1
IP Public
Posted: Sat Sep 27, 2014 7:29 am
by Bata
Hello Every body...
I am a newbie here, I'm confuse, I setup vpn server on internet, for example with 91.99.33.46 and I connect with my client correctly and don't have problem and get IP from my NAT 192.168.30.11
but I want my client get or set valid IP until my client reachable from internet...
and my range is 97.22.33.120 to 125
I don't know what should I do...?
please Help me...
Re: IP Public
Posted: Sat Sep 27, 2014 7:02 pm
by qupfer
Where is the NAT, you are speaking about? On Client side?
Basicly, you should bridge (on server side) the vpn-hub to the phys. ethernet-adapter and check, that Secure-NAT is disabled.
On client side, you set IP/netmask manual and maybe add/modify some routes on the client.
Alternativ, you bridge to new created tap-device. Give the TAP-Device the IP 97.22.33.120. On Client, you set IP to 97.22.33.121, netmask to 255.255.255.240 and gateway to 97.22.33.120.
But without any more details about your config/OS etc, nobody can help you.
Re: IP Public
Posted: Sun Sep 28, 2014 8:36 am
by Bata
Excuse me...
Dear qupfer
I'm beginner in softether ...
can you explain more details... I did that setting but not work...
I appreciate for you help...
Thank you...
Re: IP Public
Posted: Sun Sep 28, 2014 10:47 pm
by qupfer
Sorry, if my post sounded rude. It was not intended.
But, if I or anybody else should help, you must post more detailed information. How looks your client-side network, how looks your server-side network. Which OS you are using for server and client, do you use the windows GUI or vpncmd and stuff like that. Please try to be accurate as possible.