SoftEther VPN User Forum

I have installed SoftEther on two networks. Using SoftEther client, I can connect to both, and successfully access the individual network systems.
However, when I create the bridge/cascade; I cannot access the other network at all.

Primary network 192.168.0.1/24
Remote network 10.1.10.1/24
Cascade from remote to primary is online

How do I set up the IP routing between the two so the networks can 'talk' to each other? My attempts thus far have failed. And yes; I've red the tutorials & manual (10.6.4 & 3.8.1, as well as the majority of the manual).

Thank you for your time.

try using 2 Virtual Hubs and only in 1 of them enable Cascade and connect the 2 Hubs as well.

danymogh wrote:
> try using 2 Virtual Hubs and only in 1 of them enable Cascade and connect
> the 2 Hubs as well.

thanks for the suggestion...
So on the main network, cascade the remote-hub to another locally bridged hub?

Then on the remote network, continue the cascade to the main network?

Did you configure routing table on PCs?
Please show me the traceroute command result.

Thank you -- I was unaware I had to configure routing tables on each PC ... thought I could do it at the (virtual) routers...
Will skip this and go with a hardware based system then. thanks.