Page 1 of 1
Setting a private adress on a bridge
Posted: Thu Oct 08, 2015 7:01 pm
by Mada
Is it possible to set a private ip address on a bridge server running windows?
Re: Setting a private adress on a bridge
Posted: Thu Oct 22, 2015 6:40 am
by thisjun
Yes.
Re: Setting a private adress on a bridge
Posted: Tue Nov 17, 2015 7:54 pm
by Mada
thisjun wrote:
> Yes.
Ok, where? In the windows adapter settings / Network Connections?
Manual says remove windows ipv4 stack. In this case I would need it there?
Thanks
Re: Setting a private adress on a bridge
Posted: Tue Nov 17, 2015 10:28 pm
by raafat
Why do you need it ?
Re: Setting a private adress on a bridge
Posted: Wed Nov 18, 2015 7:22 pm
by Mada
Well, to get access to the bridge-computer.
It is behind ISP-NAT so I can not call it from internet side. And on the local lan, it has no ip.
So I want an ip address to call that will go through the bridge itself.
Re: Setting a private adress on a bridge
Posted: Thu Nov 26, 2015 6:28 am
by thisjun
>> In the windows adapter settings / Network Connections?
Yes.
If you want to remove IPv4 stack, you need another adapter.