How to modify Easy Set Up settings

Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
Post Reply
Posts: 1
Joined: Sun Mar 22, 2020 8:49 am

How to modify Easy Set Up settings

Post by hue » Sun Mar 22, 2020 8:57 am

i installed SoftEther Server but unfortunately on the "Easy Set up wizard" i checked only "Remote access vpn server".
Now i want to turn on "Site to site VPN server Or VPN Bridge" but can't figure out how to open the wizard. And can't find the setting anywhere else.

For clarity - in the link below is an image of what i am talking about. ... er_Manager - 2.4.5 section;

So, please, share if you have any ideas how can i modify the setting.

I have read
If you connect to SoftEther VPN Server or SoftEther VPN Bridge for which no settings have been made after being installed
- but i have already made settings for SoftEther VPN Server. I am not sure how to work around that - to make software think there are no settings already

Thank you!

Posts: 7
Joined: Thu Jan 30, 2020 12:24 pm

Re: How to modify Easy Set Up settings

Post by SilverbackNet » Mon Mar 23, 2020 7:58 am

That just sets it to one of two default configurations. The full server and bridge functionality is available either way, it's just configured a bit differently, and the defaults are very barebones anyway. Just turn off the bridge setting, and you can make any other changes you need to set it up as a central server.

Post Reply