SoftEther VPN User Forum

I have configured and tested a L2 server-bridge from my office to home network.

Office network: 192.168.0./24
Home network: 192.168.1/24

I was able to test the L2 connection by setting up each end with IPs on the same network with successful pings. I understand that I need to use L3 routing to connect and talk with my locations.

I am having a hard time wrapping my head around setting up my routes in softether server side.

In my head I thought the following was correct but it fails to ping on either side:

Virtrual Interface:
192.168.0.254 -- 255.255.255.0-- Hub Name

Routing Table
0.0.0.0-- 0.0.0.0-- 192.168.0.254
192.168.0.0-- 255.255.255.0-- 192.168.0.254
192.168.1.0-- 255.255.255.0-- 192.168.0.254

What am I missing or entering incorrectly?

Thanks

bump-- no one knows where I'm going wrong with my route tables?

90+ views and no one is able to provide a working example of their setup using L3 switching?

I am trying to figure out what the routing table would look like between two sites using a different ISP on each side. Does this matter being that I am using Azure.net? Again, I have been able to test and ping from both sides using L2 bridge. I am trying to talk with a 192.168.0/24 and 192.168.1/24 over WAN/Internet.

Thanks for any help on this

I put together an image to illustrate my path. Like I said in my post, my L2 bridge is working fine. I'm just having trouble setting up the L3 routing in order to talk with the 192.168.0.0 & 192.168.1.0 network.

So I guess this software doesn't have great support behind it...

Please refer this manual.
http://www.softether.org/4-docs/1-manua ... P_Routing)


Don't you make a localbridge to wifi adapter?