Sorry, I've red everything from manual, especially about Layer3, searched and red 100+ forum topics, etc... but still need help to solve the most important thing for my setup:
I'll have, let's say 100 equally separated HUBs,
Code: Select all
10.10.001.10 - .50
10.10.002.10 - .70
...
10.10.100.10 - .20
- my "superuser MASTER-HUB" that can "reach" every each client from those other 100 HUBs.
Code: Select all
10.10.250.10 - .20
2. It would be even better, if those "sub-PCs" could NOT connect to my PCs (only I could connect to them... if that's even possible?
( With Packet filtering maybe?)
All of these HUBs will run on the same server.
Each hub will have active SecureNAT.
I do not want to add 100+ virtual network (TAP) adapters to my PCs, nor I want to: "disconnect -> search -> connect to an other HUB" each time.
So I think the only logical choice is: using Layer 3
But I don't know exactly how?
- 3. Is one L3 switch enough?
- 4. Do I need 100 Virtual adapter or 101?
- 5. and 100 routing table? What should be the IP and what the gateway? or all 0.0.0.0 ?
- 6. I'll have to add under each SecureNAT configuration a "static routing table to PUSH" too? ... or the L3 switch does that for me automatically?
Any help is greatly appreciated!